INDEX
34
T-SERIES | SERVICE MANUAL
Screen 2- Finding devices for safe recovery
This screen indicates that Firmware Update Manager has detected at least device in safe mode, and is scanning the network for the full
list. It should take less than a minute to nd all applicable devices.
When you are sure that all your safe mode devices have been found, click Stop Scan.
Screen 3. No safe mode devices found
This popup indicates that Firmware Update Manager has not detected any devices in safe mode on the network.
Check to ensure that your safe mode device/s are connected to the same network as Firmware Update Manager.
If you are sure that a device is in safe mode, but Firmware Update Manager cannot nd it, contact your device manufacturer.
Select the devices that you wish to recover and click Start.
A pop-up is displayed conrming that you wish to proceed.
7. Click OK to start the recovery.
Firmware Update Manager will display ‘Processing Safe Recovery’, and then ‘Safe recovery Done’ when the device/s are recovered.
The Dante module will reboot automatically.
Note: You will need to power cycle the host device (e.g. the mixing console containing the Dante module) after the Dante module
automatically reboots.
Apply the appropriate rmware update to bring the module rmware back up to the latest version (follow instruction of chapter 10.2
and 10.3).
To Next Page
Loading...
Need help?
General