Powertronix spa reserves the right to modify this document without notice
Page 17 of 46
R&D – USER MANUAL DT0430-E04
ATTENTION!
Before connecting the ups make sure the lines that connect the ups mains and reserve inputs to the distribution
panel are open and disconnected make sure that the battery panel switch is open.
put warning signs on the distribution panel and battery panel to prevent accidental actions.
Figure 2.6c: UPS terminal block in three phase/three phase configuration.
*Remove cables to separate input mains from reserve.
Figure 2.6c
GND L1 L2 L3 N L1 L2 L3 N L1 L2 L3 N + N - GND
INPUT INPUT OUTPUT UPS BATTERY
MAINS RESERVE
(use only with
Separate reserve*)
Remove connetcion*
REAR UPS
To Next Page
Loading...
