Powerware 9315 - Final Modem Configuration

66
Powerware 9315 (200 kVA---300 kVA) Operation
164201036 Rev. D 041500
Final Modem Configuration
The final step in configuring the PC modem for use with the UPS is to turn off the echo
feature of the modem. Perform the following procedure.
NOTE: The brackets ([ ]) in the following steps indicate characters that require
keying in prior to pressing [ENTER].
1. Connect the modem to the PC as described in the modem manufacturer’s manual.
2. Keyin[A],[T],thenpress[ENTER].
3. Confirm that the modem responds with “OK” or “0” (zero).
4. Keyin[A],[T],[E],[0](zero),thenpress[ENTER].
5. Confirm that the modem responds with “OK” or “0” (zero).
6. Keyin[A],[T],thenpress[ENTER].
7. Confirm that the modem responds with “OK” or “0” (zero) and that the “AT” is not
echoed back to the terminal.
8. Keyin[A],[T],[&],[W],[0](zero),thenpress[ENTER].
9. Confirm that the modem responds with “OK” or “0” (zero).