PPC 300 - Page 10

300 Card Printer – User Guide
10
MAIN MENU
TOP LEVEL
Sub Level 1
Sub Level 2
Sub Level 3
Comments
> Dye Film Info. > > Dye Film ID ID XX250YMCKOK
> > Film Used 0%
> > Region 0
> > Grade Grade #0
> Cards Printed > > Cards Printed XXXX
>
Serial Number
>
>
Serial Number
XXXXXXX
>
Software Info.
>
>
Software Info.
< Firmware version >
>
Hardware Info.
>
>
Hardware Info.
< Issue number >
> Printer Info. > > Region > Region X
> Grade > Grade #X
> Reboot Printer > > Printer Initialises
Menu Notes
1. Hand Feed Mode: Hand Feed Mode enables the user to select whether cards are fed from the rear Hopper or by hand via the printer’s front panel.
The default setting is OFF.
2. Mag Test: The Mag Test option (if applicable) enables verification on encoder operation offline. Sample data is written on to the card’s magnetic stripe (by the
printer) and then read back (by the printer) to provide read/write verification.
3. Standby Time: Using the +/- keys, Standby time can be selected for 15, 60, 600 minutes or OFF.