300 Card Printer – User Guide
47
Error code 13:23
Reason: While updating the dye control calibration, the printer detected that the motor current and red and
blue duty cycles were out of range.
Error code 13:24
Reason: While updating the dye control calibration, the printer detected that the motor current and red and
green duty cycles were out of range.
Error code 13:25
Reason: While updating the dye control calibration, the printer detected that the motor current and red, green
and blue duty cycle were out of range
14: SD CARD UNSIGNED
Error code 14:0
Reason: The internal SD card did not have a valid signature.
15: HOLOKOTE INVALID
Error code 15:0
Reason: While attempting to validate a Holokote file, the printer found that the file was not in the right format.
Either it is not the right type of file, or the data has been corrupted.
16: HOLOKOTE NOT AUTH
Error code 16:0
Reason: While attempting to validate a Holokote file, the printer found that the file was not licensed for this
printer. It is possible that the file was intended for a different printer.
17: UPGRADE INVALID
Error code 17:0
Reason: While attempting to validate an upgrade file, the printer found that the file was not in the right format.
Either it is not the right type of file, or the data has been corrupted.
Error code 17:1
Reason: While attempting to validate an upgrade file, the printer found that the file was not in the right format.
Either it is not the right type of file, or the data has been corrupted.
Error code 17:2
Reason: While attempting to validate an upgrade file, the printer could not interpret the file's upgrade
commands. Either it is not the right type of file, or the data has been corrupted.
18: UPGRADE NOT AUTH
Error code 18:0
Reason: While attempting to validate an upgrade file, the printer found that the file was not licensed for this
printer. It is possible that the file was intended for a different printer.
19: SOFTWARE INVALID
To Next Page
Loading...