HOW TO DISMANTLE SYSTEM 2200
Picture 1.
The back panel of the module is
detached from the housing by way
of a screwdriver.
Picture 2.
After this, the back panel can be
pulled out together with the PCB,
but please notice the position of
the PCB as there is a number of
different positions in the house. Do
not pull the wires unnecessarily,
instead pull the PCB. Switches and
jumpers can now be moved. When
assembling the back plate and
housing, please make sure no wires
are stuck.
21
EC DECLARATION OF CONFORMITY
As manufacturer
PR electronics A/S
Lerbakken 10
DK-8410 Rønde
hereby declares that the following product:
Type: 2224
Name: Valve Controller
is in conformity with the following directives and standards:
EMC directive 2004/108/EC and later amendments
EN 61326-1
For specification of the acceptable EMC performance level, refer to the
electrical specifications for the module.
Rønde, 29 September 2008 Peter Rasmussen
Manufacturer’s signature
20
To Next Page
Loading...
