PR8000 9mt 4x2000W METAL HALIDE
01-04-2011
Start the engine like described at the chapter “12.6 ENGINE STARTING”.
Check that the circuit breaker (Fig. 5) on the control panel is in the “ON” position.
(Fig. 5)
Lower the front and rear stabilisers via the control levers located along side the control panel
(Fig. 6). The control levers enable the adjustment of each stabiliser leg (Fig. 7). In order to locate
the stabiliser you wish to move, see the diagram located on the control panel.
(Fig. 6) (Fig. 7)
To Next Page
Loading...
