PR8000 9mt 4x2000W METAL HALIDE
01-04-2011
Refer to the spirit level for the correct stability of the lighting tower (Fig. 8).
Warning! It is not possible to raise the tower if all stabilisers are not correctly positioned.
(Fig. 8)
The Mast Control Lever located on the control panel allows the mast to be raised and lowered
(Fig. 9).
The maximum height of the lighting tower is achieved when the red stripe appears on the mast.
Proceed to light the lamps via the respective circuit breakers located on the control panel.
Light the first lamp (Fig. 10) and allow 2 minutes for it to warm up, then light the next lamp,
remembering to allow each lamp to warm up for 2 minutes.
(Fig. 9) (Fig. 10)
To Next Page
Loading...
