Pratica Rocket Express - Page 17

4.3 Electric Power
.
Note: The oven must be properly configured for opmum performance
before using for the first me. Follow the steps listed below to set the oven
operang system to either 208V or 240V supply voltage based on the voltage
being supplied at the oven's receptacle. This configuraon step is only
performed on the inial set-up and installaon. The oven will not need to be
configured again as long as the supply voltage remains unchanged.
The ovens are shipped in a defaulted posion of 240V for safety unless
specified on the original purchase order. Changes to this set voltage can be
easily done by following the instrucons listed below. Please contact Praca
Technical Support for more informaon if needed +1.214 584.6269.
1. Verify the supply voltage. If this knowledge is not readily available,
please use a qualified technician or individual familiar and comfortable
with electricity to take the measurements. Care must be used to avoid
electrical shock. Confirm the electrical configuraon of the receptacle
conforms to the electrical specificaon in the table below and wrien
on the oven's data plate located on the back of the unit.
2. Connect the oven to the power supply and turn on.
3. Press for access to Menu screen.
4. Press to enter the Sengs screen.
5. Enter password 456789 and press for access to user sengs.
Note: The password may be changed (see page 34).
6. Press to access the second Sengs screen.
7. Press to enter the Voltage screen.
8. Press or to set the correct voltage. ESPAÇO ESPAÇO
9. The oven is now ready for use, press the and confirm to ESPAÇO ESPAÇO
back to the Preheang screen.
208V
OK
220/
240V
15