page 31
Several aspects of the M9.31 can be programmed which include:
• selecting U.S. standard or Metric display
• enabling or disabling password protection
• viewing the odometer, hours of use, software version, and error log
Programming Tips
Certain aspects of the M9.31 are hidden and can only be accessed using special key
presses. To avoid unauthorized use, certain rules apply. Tips to consider while
programming or viewing diagnostic information are shown below:
• Always start at the scrolling Precor banner.
• The advanced programming and diagnostic mode is accessed by pressing the
Reset key (or the red STOP button) while the Precor banner is displayed. A second
key press must occur within 1/2 second after pressing Reset (or the red STOP
button) or the display returns to the Precor banner. The third and subsequent key
presses must occur within four seconds of the previous key press or the Precor
banner returns and you will need to begin again.
• The Select and ▼▲ keys let you preview information pertinent to the program.
• Exit the programming or diagnostic mode by pressing Reset. Note that the display
remains blank for one second and any additional key presses are ignored.
Selecting a U.S. Standard or Metric Display
The M9.31 can display units of measure in either U.S. Standard or Metric. When the
treadmill is shipped from the factory it is set to display U.S. Standard units of mea-
sure. You can easily change this setting by taking the following steps:
1. Check that the M9.31 is ON. If necessary, turn ON the treadmill using the power
switch located at the front of the unit.
2. At the scrolling Precor banner, press the following keys in sequence:
Reset, Select, Speed ▼, Speed ▲, Incline ▲
The numbers 5, 6, 7, 1 appear on the display as you press the associated key.
Important: If the second key (Select) is not pressed within 1/2 second after
Reset, the display returns to the Precor banner and you need to begin again.
3. The prompt, “Select Units” appears on the display and then, the current unit of
measure appears. Any ▼ or ▲ key lets you alternate between the prompts.
Important: If you change the units of measure, previously recorded rest and
work speeds in the Interval or Weight Loss courses are cleared and reset to
1 mph (1.5 kph).
4. Once your selection is displayed, three options exist. You can,
a. press Select to accept the unit of measure being displayed and continue
with programming the treadmill. The changes are saved in memory. The
M9.31 will retain your selection even when it is turned OFF and unplugged.
b. press the red Stop button which keeps the “current unit of measure” unchanged
and advances to the next section.
Note: The “current unit of measure” is not necessarily the one being
displayed. It refers to the unit of measure that was in existence prior to
entering the “Select Units” program.
c. press Reset which keeps the “current unit of measure” unchanged, ends the
programming mode, and returns to the Precor banner.
6
Advanced Programming Techniques
To Next Page
Loading...
