page 41
CAUTION: Special care must be taken
when aligning the running belt. Turn OFF
the treadmill while adjusting or working
near the rear roller. Remove any loose
clothing and tie back your hair. Be very
careful to keep your finger or any other
object clear of the belt and rollers,
especially in front of the roller and behind
the deck. The treadmill will not stop
immediately if an object becomes caught
in the belt or rollers.
Take the following steps to align the running belt on the treadmill. To ensure your
safety, make all adjustments while the treadmill is OFF.
1. Make sure the treadmill is OFF and the running belt has completely stopped.
2. Locate the left belt adjustment bolt in the rear end cap of the treadmill. (To
determine left and right, stand at the rear of the treadmill and face the display.)
The direction you turn the bolt depends on how the belt is tracking. Make all belt
adjustments on the
left rear corner bolt
using the hex key provided.
• If the belt is off center to the LEFT, turn the adjusting bolt 1/4 turn clockwise,
which moves the running belt to the right.
• If the belt tracks off center to the RIGHT, turn the bolt 1/4 turn
counterclock-
wise
; this moves the belt to the left.
Important: Do not turn the adjusting bolt more than 1/4 turn at a time.
Overtightening the bolt can damage the treadmill
.
3. Turn ON the treadmill.
4. Stand to the side of the treadmill and press QuickStart, enter the password (if
necessary) and then increase the running belt speed to 3 mph (5 kph) by pressing
Speed ▲.
5. Observe the running belt for a couple of minutes. The belt should be centered on
the running bed. A few inches from either side of the side rail platform.
6. If the belt needs additional alignment, repeat steps 1 through 5 of this procedure
until the belt is properly aligned.
7. Press the red Stop button (the running belt slows and stops moving). To return
to the Precor banner, press Reset.
Servicing the Treadmill
Do not attempt to service the treadmill yourself except for the maintenance
tasks described in this manual. The unit does not contain any user-serviceable
parts that require lubrication. For information about product operation or service,
call 1-800-347-4404.
Long Term Storage
When the treadmill is not in use for any length of time, turn it OFF. Ensure that the
power cord is unplugged from the wall outlet and is positioned so that it will not
become damaged or interfere with other equipment or people.
CAUTION: If you hear any chafing or the
running belt appears to be getting
damaged, stop the running belt immedi-
ately by pressing the red Stop key.
Contact Precor Customer Support.
CAUTION: After entering the password, the
belt starts moving after the short warning
message, “Belt Starting 3, 2, 1,...” appears
on the display.
To Next Page
Loading...
