Precor EFX5.33 - Page 13

page 13
Diagram 5
5. Route the display console cable through the upright support. Diagram 5.
Remove any tape or wire ties on the cable and take the following steps:
a. Insert the cable into it's receptacle on the back of the display console. Just
like a telephone connection, a definite "click" is heard when a good connec-
tion is made. If you do not hear a "click," try reinserting the cable again.
b. Have an assistant hold the upright support securely while you grasp the
display console in one hand and route the cable through the upright support
with the other.
6. Attach the display console. Diagram 5. Use the four phillips-head screws (D) to
attach the display console to the upright support. Have your assistant hold the
upright support securely while you align the mounting holes and tighten the screws.
7. Position the upright support over the base. Diagram 6. Have your assistant
move the upright support close to the front of the base assembly while you
connect the cable. Make sure that the display console (on the upright support)
faces the rear of the unit.
8. Secure the upright support to the base assembly. Diagram 6. Align the mounting
holes and thread the two bolts (G) with washers (H) through opposite sides of the
upright support and into the base assembly. Finger tighten each bolt. Do not fully
tighten the fasteners until the entire unit has been assembled.
Route the cable and
attach the display
console to the
upright support.
Display console
CAUTION: Do not stretch, crimp, or
damage the cable. Excess cable may be
gently pushed into the base assembly.
Cables damaged by improper installation
will not be covered by the Precor limited
warranty.
CAUTION: As you assemble the unit, do
not fully tighten the fasteners until
instructed to do so. Finger tighten the
fasteners or use the hex key so that the
unit is stable, but the fasteners still allow
room for adjustments.
Upright support
Cable
Diagram 6
Connect the cable to
the base receptacle
and attach the
upright support.
Lower cable
connection
Upright support
Place excess cable
into the base
assembly.
Have your assistant
hold the upright
support while you
secure it to the base.
3
2
1
Two bolts (G)
with washers (H)
2
1