Precor EFX5.33 - Page 14

page 14
9. Place the base assembly on blocks. Diagram 7. Have an assistant lift the
upright support so that you can slide a block (packing material) under the front of
the unit. Ask your assistant to stabilize the unit while you rotate the rear adjust-
able feet to the highest position. This procedure lifts the base assembly off the
floor which provides better access to the fasteners.
10. Insert the front end cap into the base assembly. Diagram 8. Position the front
end cap and insert it into the base assembly tube. If necessary, use a rubber
mallet to secure the end cap.
Diagram 7 Place the base
on supportive
blocks.
Adjustable rear foot
Supportive block
Base assembly
Diagram 8 Insert the front end
cap.
Upright support
Front end cap