page 15
COMMERCIAL PRODUCTS DIVISION
Diagram 10
Installing the covers.
Rear bracket cover
Split rubber
grommet
Upright support tube
1
2
Front bracket cover
Buttonhead
screws (J)
9. Install the bracket covers. Diagram 10. Remove the two bracket covers,
and the split rubber grommet from the packaging. Remove four buttonhead
screws (J) from the Hardware kit. Then, take the following steps:
a. Use two buttonhead screws (J) to attach the rear bracket cover to the center
tube. See Diagram 10, #1. Tighten the screws with the hex key provided.
b. Position the split rubber grommet around the upright support tube. Slide the
grommet against the rear bracket cover to help secure it in place.
c. Use the remaining two buttonhead screws (J) to install the front bracket cover.
Align the mounting holes and tighten the screws. See Diagram 10, #2.
CAUTION: Do not overtighten the screws or you may inadvertently crack
the plastic covers. Damaged covers due to improper installation will not
be covered by the Precor Limited Warranty.
Note: You have completed the assembly of the EFX
®
556i. To level the unit,
continue with the steps on the next page.
To Next Page
Loading...
