page 14
COMMERCIAL PRODUCTS DIVISION
c. Wrench tighten using a ⁹⁄₁₆-inch socket wrench. Diagram 8.
Important: Once the fasteners are secured, use a hex torque wrench to
tighten the two linkage arm screws to 200 in-lbs.
Diagram 8
Secure the rear handlebar linkage.
Handlebar linkage
Wrench tighten the screw. Once it
is secured, use a torque wrench
set at 200 in-lbs.
Diagram 9
Align and secure
the front portion of
the handlebar
linkage. Cap the
rear portion.
1
2
Gap around
edge of linkage
should remain
consistent
7. Align the handlebar linkage with the handlebar. Diagram 9, #1. Return to
the handlebar bracket and straighten the handlebar so that the linkage below it
is set close to a 90 degree angle. Tighten the three screws on each handlebar
using a ¹⁄₄-inch hex key.
8. Install the plastic cap onto the linkage arms. Diagram 9, #2. Position the
plastic cap over the fasteners and press on it so it snaps it into place.
Black plastic cap
To Next Page
Loading...
