4. While holding the lift platform with one hand, carefully push/pull the left and right lift
pivot pins outward through the pivot brackets enough to allow the lift platform to drop
and be removed.
5. Remove the two lift pivot pins from the frame rails. (missing or bad snippet)
Installation Instructions
1. Inspect the left and right lift platform pivot bushings for wear. Use the lift pivot pin to
check the fitment. If the fitment is not snug or irregular, then replace the bushings.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 216
6 Replacement Procedures
Lift Platform Replacement
To Next Page
Loading...
