Chapter 1
Beginning the Assembly
To assemble the equipment, you will need to attach the PVS
to the console and route several cables.
Important: Assemble the equipment according to the guidelines
in this manual to ensure that you do not void the Precor Limited
Warranty. Any damage caused during installation is not covered
by the Precor Limited Warranty.
Installation Requirements
Prior to assembly, make sure you have the required tools and
hardware. You will need the following tools to perform this
assembly:
Phillips screwdriver
³₁₅-inch socket head screwdriver
Set of metric hex wrenches
Set of SAE hex wrenches
Hex-drive torque wrench with #2 Phillips screwdriver bit
To Next Page
Loading...
Need help?
General