Chapter 5
Maintenance
To keep the equipment functioning properly, perform the
minor maintenance tasks in this section at the intervals
suggested. Failure to maintain the equipment as described in
this section could void the Precor Limited Warranty.
To reduce the risk of electrical shock, always
disconnect the equipment from its power source
before cleaning it or performing any maintenance
tasks. If the equipment uses an optional power
adapter, disconnect the adapter.
Cleaning the PVS Screen
Precor recommends that you clean the PVS at least one time
per day.
To remove dust and dirt from the PVS:
ļ Use a clean, soft, lint-free cloth moistened with isopropyl
alcohol solution to remove dust, dirt, and fingerprints
from the screen surface. The alcohol solution may range
in strength from a 1:1 solution (total concentration
between 45% and 50%) to a typical full-strength solution
(normally 91% to 99%). You may also use commercially
available isopropyl alcohol solutions within this range, or
flat-screen cleaning wipes moistened with isopropyl
alcohol.
To Next Page
Loading...
Need help?
General