Beginning the Assembly 45
7. Replace the back plate. Insert the base tabs first, and then
apply pressure to engage the side tabs. Replace the
Phillips-head screw. Do not apply more than six
inch-pounds of torque.
Note: You may want to test the PVS before replacing the
back plate.
Figure 55: Back plate attachment
Testing the PVS
To test the PVS:
1. At the base of the treadmill, plug the power cable into the
power extension module and connect it, along with the
coaxial cable, into the strip provided for Cardio Theater
equipment.
2. Observe whether the PVS (screen and integrated
controller) is receiving power while you configure the
channels using the integrated controller and check the
audio connection. For instructions on how to configure
channels and troubleshoot the PVS, refer to the
appropriate PVS operation and maintenance guide
provided in the box.
Note: A green LED illuminates on the integrated controller
when it is connected to a power source.
To Next Page
Loading...