PRG BEST BOY - Page 65

BEST BOY
®
HP SPOT LUMINAIRE USER MANUAL 57
Gobo out of zero range
When zeroing gobo wheels, the wheel is
too far away from zero to set the position
Move wheel closer to home position
before zero command
Head Fan Error Fan not running properly Check fan
In Free Mode: Can’t Lock Free mode is enabled
Use pan/tilt menu to change from "free"
to "lock"
Lamp Off
Fan Error: Cannot strike lamp while any
fan is in error state
Check fan, fan cabling
Lamp Off: Over Temperature Head temperature too high Check fans
Lamp over threshold
Lamp hours above recommended
maximum
Change lamp
Must Unlock via Free Option Lock is enabled
Use pan/tilt menu to change from "lock"
to "norm"
Plenum Fan Error Fan not running properly Check fan
PMD Motion Error
Mechanism's actual position is too far
from its commanded position
Check mechanism motion
Framing Motor Disabled Framing not running properly Recalibrate, check mechanism motion
Stack Fan Error
One or more stack fans not running
properly
Check fan, fan cabling
Temp over threshold Temperature too high Check fans/filters
Tip Fan Error Fan not running properly Check fan
UPE Fans Error
Upper Enclosure fans not running
properly
Check fan, fan cabling
Yoke Fan Error Fan not running properly Check fan
Error Code Explanation Solution