EasyManua.ls Logo

Primayer Eureka3 - Antenna Socket; Touch Screen; USB Ports; Headphone Jack Socket

Primayer Eureka3
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Eureka3 User Manual
Eureka3 Page 14
3.2.3 Antenna Socket
The antenna connection allows either the standard antenna or the Magnetic Vehicle Mount antenna to
be connected to PrimeTouch.
3.2.4 Touch Screen
The touch sensitive screen shows information and software buttons. The screen works well in all
lighting conditions and can be operated wearing gloves if required. The brightness of the display can
be adjusted as required.
3.2.5 USB Ports
Two USB ports are provided for the connection of USB devices.
3.2.6 Headphone Jack Socket
The headphone jack allows the connection of the supplied headphones to monitor the sound being
received from the transmitters. The sound from the selected sensor is played through both headphone
earpieces.
3.2.7 Charging/Direct Sensor Input Socket
The socket allows PrimeTouch to be charged in the transport case and also allows the connection of
external sensors. Two types of external sensor are available:
External accelerometer sensor
Hydrophone
3.2.8 Power Save
To maximise the battery life, PrimeTouch has a power save function. This reduces the amount of
battery power consumed when the unit is inactive. Data is not lost when PrimeTouch enters power
save.
Period of
Inactivity
Result
Reactive Action
After 60 seconds Screen dims Tap the screen to restore normal
brightness.
After 5 minutes PrimeTouch goes into power save A short press of the On/Off switch
or the Home button will return the
PrimeTouch to normal operating
mode.
After 60 minutes PrimeTouch beeps for 30 seconds
before fully powering off
A short press the On/Off switch or
the Home button when PrimeTouch
is beeping will stop the unit
powering off. The automatic power
off will again occur after another
period of inactivity lasting 60
minutes.
3.2.9 Charging PrimeTouch
PrimeTouch is charged in the transport case. Connect the charge lead in the transport case to
PrimeTouch. Connect the mains adaptor to the main electrical supply or the vehicle charge lead to the
vehicle supply (12Vdc).
Only Eureka3 charge leads should be used to
charge the PrimeTouch. DO NOT attempt to use
Eureka2 or Eureka Digital charge leads, as
damage may occur which will not be covered by
warranty.

Table of Contents

Related product manuals