Eureka3 User Manual
Eureka3 Page 21
5.2.2 Brightness Slider
This slider controls the brightness of the screen. Move the slider up to increase the brightness and
down to decrease the brightness. There is a slight delay while the display changes brightness.
5.2.3 Units Button
The units button changes the unit measurement type used by PrimeTouch. The options are Imperial
and Metric. Each time the button is tapped the type of units selected will cycle between imperial and
metric.
5.2.4 Date/Time Display
This part of the screen shows the system date and time. To change any of the settings tap in the
required field, the numeric keyboard will open, tap the values required and then the return key to
complete the change. The next data field will be selected; enter the required value or tap return to
move onto the next field. When all the fields have been cycled though, the numeric keyboard will
disappear. The back space key can be used to delete characters as required.
5.2.5 Language Button
The language button selects the language used by PrimeTouch. To change the language, tap the
button and a list of languages is shown on the screen. Tap the required language. The Settings
Screen will now be updated to the new language.
5.2.6 Velocities Table Button
The Eureka3 software allows customisation of the velocity values used for correlation. The tables
programmed into the unit have been formulated after many years’ experience, and should not be
changed without proper thought. Changing the velocity used for a correlation will result in a different
leak position.
To access and change the velocities table, tap the velocities table button; this will open the Velocities
Table Screen (see section 5.3).
5.2.7 Tick Button
Tap the tick button to return to the Introduction screen.
To Next Page
Loading...