12 Label Stock
Present Options:
Do not present. In this mode the label stock does not move after the last label is printed.
This means that part of the last label printed is still in the printer. This should be used only
if you have a label rewinder attached.
Present after no activity. This setting will present at the end of a print job if the printer
does not receive another print job within one second of the last print job in the queue. You
can use this feature to present at the end of multi-copy job, multi-page job or multiple indi-
vidual jobs in queue.
Present after specified number of labels. This option will present after the number of
labels specified in the "Cut/Present After___ Labels" setting above. Change the value and
then click "Set" to send it to the printer. The quantity will change on the setting to reflect
the change.
Present after every label. This setting will cause the printer to feed the last label printed
forward so that it and the previously printed labels can be torn off using the tear bar. If no
other jobs are sent to the printer within one second after the last label has printed, the last
printed label will present for tear off.
Present after button press. This setting will present after you press the Load/Feed button
on the printer. This can be used after one label or an entire job.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
