100962 G PUBLICATION DATE 24 JUN 2008.DOC PROGRAMMING MANUAL 53
T THE RINSE SEQUENCE
• No temperature can be programmed as a Rinse is only dedicated for cold water.
Top Soap-Hopper washing machines
• 3 Inlets can be programmed. I1, I2, I5 and I6 are available.
• The suggested inlet valves are I2, I5 and I6.
• Insert the desired inlet valves. Press the ENTER button for
confirmation.
Front Soap-Hopper washing machines
• 2 Inlets can be programmed. I1 and I2 are available.
• The suggested inlet valve is I2.
• Insert the desired inlet valves. Press the ENTER
button for confirmation.
Attention
!
If you insert other inlet valves than the suggested ones,
Problems can occur at the water fill process.
• The suggested Water Level corresponds with the Normal
High water level.
• The suggested water level depends on the machine type.
• Check the corresponding table paragraph 3.4.
• The water level can only be programmed within certain limits.
• Insert the desired water level. Press the ENTER button for
confirmation.
• The suggested drum speed value depends on the machine
type.
• Check the corresponding table paragraph 3.4.
• The drum speed value can only be programmed within
certain limits.
• Insert the desired speed value. Press the ENTER button for
confirmation.
• If you don‘t want to get into the supply sub-menu, press the
ARROW DOWN button.
• Press the ENTER button to get into the supply sub-menu.
• Default: all the supplies are switched off. (time = 0)
Prewash
Wash
Cooldown
Rinse
Final Rinse
Soak
Flush
S
ra
No wash
P:Pr XX Step XX
Inlet : _ _ _
P:Pr XX Step XX
Level : _ _
P:Pr XX Step XX
RPM : _ _
P:Pr XX Step XX
Supply ?
!
To Next Page
Loading...
