100962 G PUBLICATION DATE 24 JUN 2008.DOC PROGRAMMING MANUAL 95
E36 Termic Tumbl
Defective motor
contactor
Fatal error : Full stop At tumble sequence
E37 No Drain Sp
Drain failure at the
Spray Sequence
Full stop + tumble Spray Sequence
E38 No Recycle
The Tank with recycle
water is empty
Warning at the End.
Front Hopper Mach. only
Wash step
E39 Out of Soap
The Soap Supplies
are running Out of Soap
For Info only Wash step
E40 No Fill Rec
Fill failure due to an
empty water recycle
Tank
Full stop + Request for
Continue
Top Hopper Mach. only
Wash step
E41 Service Due Service Due Warning For Info only
Open door = reset
End cycle
E42 Connection
No Network
Connection
For Info only Data Transfer Networking
E43 Voltage Par
Wrong Voltage
Range Selection
Make correct selection Configuration menu
E44 Model type
Wrong Inverter Model
Type
Make correct selection Configuration menu
E45
No Speed Sensor
Signal
No Speed pulses
when drum turns.
Continue + Warning At spin sequence
(F120 only)
E46 Brake Closed Brake Stays Closed Full stop + safety time At spin sequence
(F120 only)
E47 Brake Wear Out
Friction blocks brake
are wear-out
Full stop + safety time Any time
(F120 only)
E48 Brake Open Brake Stays Open Continue + Warning At spin sequence
(F120 only)
E49
UnBalance
Switch At Wash
Air suspension
without compressed
air
Full stop + safety time Wash action
(F120 only)
E50
No Second
Acceleration
Ramp
Missing wire bridge
inverter / wrong
inverter parameters
Continue At spin sequence
(F120 only)
E51
No Third
Acceleration
Ramp
Missing wire bridge
inverter / wrong
inverter parameters
Continue At spin sequence
(F120 only)
E52 Board Memory
PCB-EEPROM
CRC failure
Don’t start At Power Up
E53 Board Data
PCB-EEPROM
Data out of range
failure
Don’t start At Power Up
E54 Lock Active
At standby door
lock is locked
nevertheless door
is open
Don't start At Standby
E55 Lock Start
After pressing Start
door lock is locked
nevertheless door
is open
Don't start At Start cycle
MCB40
(E52)
Inner Door
Inner Door handle not
locked
Full stop + safety time At wash speed
(MB only)
MCB40
(E53)
Magnet Sensor 1
Safety Distance inner
door exceeded.
Full stop + tumble.
(Reset Service menu)
At wash speed
(MB only)
MCB40
(E54)
Magnet Sensor 1
Safety Distance inner
door exceeded.
After 2x softw tilt, Full stop +
tumble.
At spin sequence
(MB only)
MCB40
(E55)
Magnet Sensor 2
Safety Distance inner
door exceeded.
Full stop + tumble.
(Reset Service menu)
At wash speed
(MB only)
MCB40
(E56)
Magnet Sensor 2
Safety Distance inner door
exceeded.
Full stop + tumble.
(Reset Service menu)
At spin sequence
(MB only)
To Next Page
Loading...