24 PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC
avoid the shrinking of the garments. (Takes more time)
See Chapter 5.
• Yes is the default value.
• Yes : Automatic Cool-down enabled.
No : Automatic Cool-down disabled.
• Press the ENTER button to confirm.
• With the Wait for Temperature function, The Full Control
Wash Computer will put the process time on Hold as long as
the programmed temperature hasn‘t been reached. Once the
temperature has been reached, the time will be released.
• Yes is the default value.
• Yes : Wait for heat enabled.
No : Wait for heat disabled.
• Press the ENTER button to confirm.
• The operator can interact immediately on the water inlet,
drain, heating and spin speed functions.
• By selecting the Manual override function, the special
function buttons on the key board will become functional.
• Yes is the default value. (No for MB-machines)
• Yes : Manual override enabled.
No : Manual override disabled.
• Press the ENTER button to confirm.
Attention
!!!
The special function buttons will only activate the
corresponding Outputs if the safety requirements are
fulfilled.
Example : If there is No water in the drum, it will not be
possible to switch on the heating by pressing the special
function button “HEATING”
• The Full Control Computer will control the water temperature
at the water fill process. By switching the cold and hot water
inlet valves On and Off, the programmed temperature will be
reached at the end of the water fill process.
• For High temperatures extra heating will be required after the
fill process.
• For some applications, the automatic temperature control
should be switched off. This can be done by disabling
the Temperature Balance function.
• Yes is the default value.
• Yes : Temperature balance enabled.
I:Wait for
Temp : Yes
I:Manual
override : Yes
I:Temperature
Balance : Yes
!
To Next Page
Loading...
