Primus RF18 - Step ④: Programming the Wash Part

42 PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC
5.4. STEP } : PROGRAM STEP FUNCTION
T ADDING A STEP AT THE END OF THE PROGRAM
• If you create a new program, new steps will be added at the
end of the program.
• Press the ARROW DOWN button if you don‘t want to Add a
new step.
• Press the ENTER button if you want to add a new step.
Goto ~ °
T EDIT A STEP
• If you edit a step, you will change values or list elements
from an existing step.
• Press the ARROW DOWN button if you don‘t want to Edit a
step.
• Insert the Step number.
If the number is not accepted, this means that the step is not
available.
• Press the ENTER button to confirm your selection.
Goto ~ °
T INSERT A STEP
• If you insert a step, a new step will be inserted between two
existing steps.
• Press the ARROW DOWN button if you don‘t want to
INSERT a step.
• Insert the Step number.
If the number is not accepted, this means that there is no
step with a step number = inserted number – 1
available. A
new step can only be inserted between two available steps.
• Press the ENTER button to confirm your selection.
Goto ~ °
T VIEW A STEP
• Before making changes in a wash program, it‘s
recommended to have a look at the actual settings by the
view function.
• Press the ARROW DOWN button if you don‘t want to View a step.
P:Add
Ste
p
P:Edit
Step : _ _
P:Insert
Step : _ _
P:View
Step : _ _