6 PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC
3. BASIC DESCRIPTION OF CONTROLS
3.1. GENERAL
T THE CONTROL OFFERS :
99 programmable programs (including 15 pre-programmed ones)
Control of signal voltages for external pumps or liquid supply dispensers
Redistribution of the garments to avoid imbalance
Automatic temperature balance at the water fill process
Setting the machine options and configuration
Multiple languages can be selected ( one at a time)
T IN OPERATION THE FOLLOWING DATA IS DISPLAYED :
The selected program
The active wash step
The remaining program time
The name of the sequence
Indication of wait for heat ( if selected )
The water level and temperature can be viewed
Diagnostic messages
T THE OPERATION MENU :
A program can be manually Shortened, Extended, Stopped.
A pause can be programmed
Special function buttons allow direct operation of selected components ( water valves, ect.)
Program overview
Service information
T THE HARDWARE AND SOFTWARE OF THE FULL CONTROL WASH COMPUTER :
Easy operation by a comprehensive keypad
The hardware contains 1 electronic board
(Old wash computer MCB 40 = 2 piece execution : Micro-Controller Board (display) & Power Board)
The wash machine control software is implemented in a EPROM that can be easily replaced
The Wash Programs are kept in EEPROM memory ( non-volitile memory)
To Next Page
Loading...
