Printronix P5215 - Page 111

Submenu
111
SFCC & Pwrup
This option has several suboptions which define the SFCC and
power-up configuration used with VGL.
SFCC
This option selects the Special Function Control Code. The default
value is the caret ^ (decimal 94). Valid values are 17 through 255.
Throughout this manual, the caret is used as the SFCC. Run a
configuration printout to determine the currently selected SFCC.
Power Up ^X
• Disable. The default.
• Enable. Selects the ignore mode as the power-up default, and
selects the graphics mode ^PY as the power-up default. All
characters are ignored until a ^A command is received.
Power Up ^F
• Disable. The default.
• Enable. Selects free format mode as the power-up default, and
selects the graphics mode ^PY as the power-up default. Free
format causes the VGL to ignore carriage returns, line feeds
and all characters below 20 hex sent from the host.
Power Up ^PY
• Disable. The default.
• Enable. Selects the graphics mode ^PY as the power-up
default.
LPI
The number of lines to be printed per inch. For example, at 6 lpi
there is 1/6 inch from the top of one print line to the top of the next
print line.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es