Chapter 4 LinePrinter Plus Emulation
154
Reset Cmd CFG Ld
When the printer receives a host data stream reset command (ESC
@ or ESC[K) in addition to resetting printer variables, the selected
configuration will be loaded.
• Disable. The active emulation parameters are loaded when the
reset command is executed.
• Power-Up Config. The power-up configuration is loaded when
the reset command is executed.
• Current Config. The currently selected configuration is loaded
when the reset command is executed.
• Factory Config. The factory installed configuration is loaded
when the reset command is executed.
Downloaded Fonts
Allows you to download a substitution table to replace any
character in the current character set with a different character in
the same font.
• Char Operations. Allows you to delete a character from flash,
load a character from flash, save a character to flash and
delete a character from RAM.
• Ld Char at Pwrup. Allows you to disable or enable loading a
character at power up.
• Set Operations. Allows you to delete a character set from
flash, load a character set from flash, save a character set to
flash, and delete a character set from RAM.
• Ld Set at Pwrup. Allows you to disable or enable loading a
character set at power up.
• Set Substitution. When this option is activated, the character
set overlay in RAM is activated. This can also be accomplished
through a host command of SFCC RX. In either case, a flag is
set indicating that the substitution table is active. If the power-
up configuration has Ld Set at Pwrup and Set Substitution both
enabled, the character set overlay will automatically be
activated at power-up or during a soft reset. See the
LinePrinter
Plus Programmer’s Reference Manual
for more information.
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page
Loading...
