To Next PageTo Next Page
How to fix 'SHUTTLE STALL' on Printronix Printer?
To address a 'SHUTTLE STALL' on your Printronix Printer, set the platen lever to match the thickness of the paper, but not too tightly. Check and adjust the platen gap. Inspect the ribbon mask for deformation that snags and interferes with shuttle movement. If the fault source is not apparent, contact your authorized service representative.
What does 'ERROR: DC PROGRAM NOT VALID' mean on my Printronix Printer?
If your Printronix Printer displays 'ERROR: DC PROGRAM NOT VALID', download the program again. If the message appears, replace the flash memory SIMM.
What does 'PLATEN OPEN TIMEOUT' mean on my Printronix Printer and how to fix it?
If your Printronix Printer displays a 'PLATEN OPEN TIMEOUT' message, close the platen lever.
How to resolve 'RIBBON STALL' on Printronix Printer?
To resolve a 'RIBBON STALL' on your Printronix Printer, check the ribbon path for any jams. Also, try turning the Ribbon Tension Knob clockwise a few rotations. If the issue persists, consider installing a new ribbon.
What to do if Printronix Printer displays 'CLEAR PAPER JAM'?
To address the 'CLEAR PAPER JAM' message on your Printronix Printer, first, clear the jam and reload the paper. If the message reappears, it is recommended to contact your authorized service representative.
How to resolve 'BUFFER OVERRUN' error on Printronix Printer?
To fix a 'BUFFER OVERRUN' error on your Printronix Printer, make sure the printer's serial interface configuration settings match those of the host computer. Check the Data Protocol, Baud Rate, Data Bits, Stop Bits, Parity, Data Terminal Ready, and Request to Send settings.
What does '06 HOST REQUEST' mean on Printronix Printer?
The '06 HOST REQUEST' error on your Printronix Printer indicates that either the host computer or the printer controller requires attention.
What to do if Printronix Printer shows 'STACKER FULL'?
If your Printronix Printer displays 'STACKER FULL', remove the paper from the stacker.
What does 'PAPER OUT TIMEOUT' mean on my Printronix Printer and how to fix it?
If your Printronix Printer displays a 'PAPER OUT TIMEOUT' message, it means you need to load paper into the printer.
What to do if my Printronix Printer is 'PRINTER HOT'?
If your Printronix Printer displays 'PRINTER HOT', inspect the printer's environment. If the area is hot or dusty, relocate the printer. If this issue occurs frequently, it's best to contact your authorized service representative.
Lists MTBF for various printer models under specific print conditions.
Specifies the average time required for installation and repair tasks.
Outlines the requirements for routine preventative maintenance.
Lists specific spare parts for the P7X05 model.
Lists specific spare parts for the P7X10 model.
Lists specific spare parts for the P7X15 model.
Lists specific spare parts for the P7X20 model.
Lists specific spare parts for the P70XX ZTP model.
General| Print Technology | Line Matrix |
|---|---|
| Resolution | 180 x 144 dpi |
| Print Width | 13.6 inches |
| Weight | 145 lbs |
| Connectivity | Parallel, Serial, Ethernet, USB |
| Paper Handling | Continuous form |
| Noise Level | 55 dBA |
