Pro-face PS5000 Series - Certifications and Standards

PS5000 Series (Slim Panel Type Atom Model) User Manual
13
Certifications and Standards
Agency Certifications
Pro-face submitted this product for independent testing and qualification by third-party agencies.
These agencies have certified this product as meeting the following standards:
 Underwriters Laboratories Inc., UL 60950 and CSA 60950 (Information Technology
Equipment).
 CCC, RCM, and EAC certification. Refer to product markings.
NOTE: For information on certifications and standards, such as certified models and certificates,
see product markings or the following:
http://www.pro-face.com/trans/en/manual/1002.htm .
Compliance Standards
Pro-face tested this product for compliance with the following compulsory standards:
 United States:
 Federal Communications Commission, FCC Part 15, Class A
 Europe: CE
 2006/95/EC Low Voltage Directive, based on IEC 60950 or IEC 61010-2-201
 2004/108/EC EMC Directive, class A, based on IEC 61006-2 and IEC 61006-4
 Australia:
 Standard AS/NZS CISPR11
Qualification Standards
Pro-face voluntarily tested this product to additional standards. The additional tests performed, and
the standards under which the tests were conducted, are identified in the environmental
characteristics.
Hazardous Substances
This product is compliant with:
 WEEE, Directive 2012/19/EU
 RoHS, Directive 2011/65/EU
 RoHS China, Standard SJ/T 11363-2006
 REACH regulation EC 1907/2006
End of Life (WEEE)
The product contains electronic boards. It must be disposed of in specific treatment channels. The
product contains cells and/or storage batteries which must be collected and processed separately
when they have run out and at the end of product life.
Refer to the section Maintenance to extract cells and batteries from the product. These batteries
do not contain a weight percentage of heavy metals over the threshold notified by European
Directive 2006/66/EC.
European (CE) Compliance
The products described in this manual comply with the European Directives concerning
Electromagnetic Compatibility and Low Voltage (CE marking) when used as specified in the
relevant documentation, in applications for which they are intended, and in connection with
approved third-party products.