Hardware Modifications
64
Before Modifications
Section 8.1
Before Modifications
Before Making Modifications
Introduction
For detailed installation procedures for optional units, refer to the OEM (original equipment
manufacturer) installation guide included with the optional unit.
During operation, the surface temperature of the heat sink may exceed 70 °C (158 °F).
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
Remove all power from the device before removing any covers or elements of the system, and
prior to installing or removing any accessories, hardware, or cables.
Unplug the power cable from both the Industrial Personal Computer and the power supply.
Always use a properly rated voltage sensing device to confirm power is off.
Replace and secure all covers or elements of the system before applying power to the unit.
Use only the specified voltage when operating the Industrial Personal Computer. The AC unit
is designed to use 100...240 Vac input. The DC unit is designed to use 24 Vdc input. Always
check whether your device is AC or DC powered before applying power.
Failure to follow these instructions will result in death or serious injury.
DANGER
POTENTIAL FOR EXPLOSION IN HAZARDOUS LOCATION
Do not use this product in hazardous locations.
Failure to follow these instructions will result in death or serious injury.
WARNING
RISK OF BURNS
Do not touch the surface of the heat sink during operation.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
To Next Page
Loading...