Dimensions / Installation
30
Installation Requirements
Important Mounting Information
Overheating of the system can cause incorrect software behavior. To prevent the system from
overheating, be aware of the following:
The environment characteristics of the system must be respected.
The Slim Panel is only permitted for operation in closed rooms.
The Slim Panel cannot be situated in direct sunlight.
The Slim Panel vent holes must not be covered.
When mounting the Slim Panel, adhere to the allowable mounting angle.
WARNING
UNINTENDED EQUIPMENT OPERATION
Do not place the Industrial Personal Computer next to other devices that might cause
overheating.
Keep the Industrial Personal Computer away from arc-generating devices such as magnetic
switches and non-fused breakers.
Avoid using the Industrial Personal Computer in environments where corrosive gases are
present.
Install the Industrial Personal Computer in a location providing a minimum clearance of 10 mm
(0.39 in) or more on the left and right sides, 50 mm (1.96 in) or more on the rear side, and
100 mm (3.93 in) or more above and below the product from all adjacent structures and
equipment.
Install the Industrial Personal Computer with sufficient clearance for cable routing and cable
connectors.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
To Next Page
Loading...