Pro-Form 440R - Page 10

10
8. Attach the Rear Stabilizer Cover (2) to the Rear
Stabilizer (3) with an M5 x 10mm Screw (101).
8
101
3
2
7
7. See the inset drawing. Route the end of the
Bungee Cord (45) around the Small Pulley (5) on
the Rear Stabilizer (3) as shown.
Make sure that the Bungee Cord (45) is not
twisted. Attach the Bungee Clip (97) to the indi-
cated hole in the Rail Attachment Bracket (43).
43
45
97
Hole
3
5
45
3