Pro-Form Fusion 6.0 LX - Page 16

34. Attach the Butterfly CaMe (73) and a Weight Cap
(67) to the indicated Weight Tube (75) with an
MIO x 50mm BoUt(106) and an MIO NyUon
Locknut (111).
35. Locate the Low CabJe (70). Route the CaMe
through the Leg Lever (15) and the CurUPost
Upright (10).
Attach a Pulley (43) to the Leg Lever (15), over
the Low Cable (70), with an MIO x 45mm Bolt
(95) and an MIO Nylon Locknut (111).
36. Attach a Pulley (43) inside the Curl Post Upright
(10), over the Low Cable (70), with an MIO x
65mm Bolt (110), two MIO Washers (109), two
1/2" Spacers (68), and an MIO Nylon Locknut
(111).
37. Route the Low CaMe (70) through the Right Seat
Upright (11) and the Right Upright (7) and under a
PuUUey(43). Attach the PuUUey,an MIO Washer
(109), and two HaUlFinger Guards (46) to the
Right Base (1) with an MIO x 45mm BoUt(95) and
an MIO NyUonLocknut (111).
34
35
,, 73-
11
6]
106
75-
36
111
43
7O
15
95
111
43
110
J
68
37
109
16