- 3 -
Pro Spot PR-8
GB/US/2000-08 PRO SPOT
A1. Warnings, important notes and information
Follow these safety rules to ensure safety for the operator and other persons.
In addition to the safety signs shown on page 5, the following warnings and important notes
will be found elsewhere in these instructions.
Warning! Make sure you know where fire extinguishing
equipment is.
Important! Risk of damage to materials close to the weld,
e.g. glass or textiles.
Important! Ensure that all electrical equipment within the working
area is disconnected. Beware risk of interference.
Important! When in Operating Mode 4, the earth connection
must be made to the supporting body sheet and not to the part to
be welded.
Important! The user must have the necessary knowledge for
use of this equipment.
REMEMBER GENERAL FIRE SAFETY!
Pay attention to the fire safety regulations. Welding is always classified as a fire risk
operation.
Welding where there is flammable or explosive material is strictly forbidden.
Remove flammable material from the immediate vicinity of the welding site.
Fire extinguishers must always be on site where welding is taking place.
NOTE: Sparks may cause fire many hours after completion of welding.
WATCH OUT FOR THE MAIN VOLTAGE!
Take care of the cables - the connection cable must not be compressed, touch sharp edges
or hot work pieces.
Faulty cables are always a fire risk and highly dangerous.
Do not locate the welding machine on wet surface.
A. Safety
To Next Page
Loading...
