ProArc PT-200s - Autorun Functionality Configuration; Arc Signal Feedback for Rotation; Start Sequence and Position Control; Foot Switch Operation Modes

16
2.11 AUTORUN FUNCTION
X：Disable feature.
O：Enable feature.
1
X：Turn table doesn’t wait Arc on feedback signal.
Turn table start rotation T2 sec after welder on signal is active.
O：Turn table waits for Arc on feedback signal.
Turn table start rotation T2 sec after receiving arc on feedback.
2 Reset current position to 0 when auto start is activated.
3 Automatically return turn table to original position.
4 Foot switch function: Rotate CW, rotate CCW, Auto Start.