Profitec Pro 600 - 9 DISPOSAL; 10 CE CONFORMITY; TROUBLESHOOTING COMMON ISSUES

ENGLISH
Bedienungsanleitung / Instruction manual Profitec PRO 600 - I 31
9 DISPOSAL
WEEE Reg.-Nr.: DE 97592029
This product complies with EU Directive 2012/19/EU and is registered according to WEEE (Waste Electrical
and Electronic Equipment).
10 CE CONFORMITY
Conformity
The product complies with the following EU Directives:
Machine: 2006/42/EC
Low Voltage: 2014/35/EU
EMC: 2014/30/EU
PED: 2014/68/EU
EN-Directives: EN 292-1, EN 292-2, EN 60335-1, EN 60335-2-15 or EN 60335-2-75,
EN 55014, EN 61000-3, EN 61000-4, ENV 50141, EN 55104
11 TROUBLESHOOTING
Problem
Possible Cause
Troubleshooting
The machine is switched on, but
the machine does not work.
Water has been refilled, PID-
display is off
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct
position. The side of the floater
with the magnet point must face
towards the inside of the
machine. The floater itself must
be inserted with the magnet point
on the upper part of the floater
side.
The machine is switched on, but
the machine does not work.
PID-display is turned off: There is
not enough water in the fresh
water tank
Refill water.
The water tank is not fixed
properly.
Fix the water tank properly.
Portafilter/ brew group is
dripping.
Portafilter is not fixed properly.
Fix the portafilter properly.
Group gasket is broken.
Change group gasket and
shower screen.
“CLn” is shown on the display.
The cleaning mode is
programmed
Clean the brew group. After
having operated the brew lever
10 times, the “CLn” will
disappear.
There is a dot on the display.
The display is switched off.
Press + to turn it on.
No Steam
The Steamboiler ist switches off
Go in to the PID-Menu and set
the steamboiler ON
The Machine is cold qickly
The Eco-Mode is ON
Turn the Eco-Mode in the PID-
Menu OFF ore set the switch off
countdown longer