Profitec Pro 700 - Machine Installation; Preparation for installation; Electrical connection; Water supply connection

ENGLISH
Translation of the German original user manual 26
Caution!
Danger of injury: The following parts are hot or may become hot:
• Area of the valves
• Steam wand and hot water wand
• Brew group
• Portafilter
• Body (upper part and side frames)
4. MACHINE INSTALLATION
The installation is to be carried out exclusively by qualified specialists, according to the
following instructions and in compliance with valid laws and local regulations.
4.1 Preparation for installation
• Place the machine on an even and stable surface.
• Never place the machine on hot surfaces.
• Place the machine on a
water-proof surface, as the machine may at some point leak
water.
4.2 Electrical connection
• Make sure that the local main voltage supply corresponds to the information given
on the type plate on the front panel of the espresso machine.
• Make sure that you use the correct power plug for your country.
• Plug the machine into a grounded socket only and do not leave it unattended.
• Do not roll or bend the power cord.
• Do not use an extension cord / do not use a multiple socket.
4.3 Water supply connection
Important
Make sure that the fixed water connection of your machine is connected to a potable
water supply having an operating pressure at least 100 kPa and does not exceed 200 kPa.
We recommend
using a pressure regulator and a shut-off valve in case the operating
pressure exceeds 200 kPa or frequently fluctuates.
The shut-off valve should be easily accessible, so that the water flow may be stopped at
any time.
Make sure that the shut-off valve is closed or turned off when the machine is
not in use to prevent any possible water leakage.
connection direct water connection
4.3.1 Machine in use with a direct water connection
The water connecting hose is to be connected to the water supply adapter (image 1) at the bottom panel of
the machine.
When using the machine with direct water supply, the valve has to be turned towards the opposite side of
the water supply adapter opening (image 1). The water supply adapter is located in the rear part of the
Before use, please make sure that your water tap is always open during water-connection usage so that
the machine never runs out of water!