ENGLISH
Translation of the German original user manual 38
If the machine will not to be used for a long period of time, it is recommended to
.. clean the brew group (see instructions in chapter 7.2). Afterwards, please do not clamp the portafilter
back into the group.
..to empty the boilers. Turn the switch of the operational machine to position off. Open the hot water
valve and the boiler water is now discharged by the remaining pressure through the hot water release.
Close the hot water valve after the water has been released. The coffee boiler is emptied out via the brew
group. Activate the brew group lever and release the water into the drip tray. Please make sure some
water remains in the coffee boiler. Start-up of the machine is the same as initial start-up (item 5.).
How to forth
• If possible, use cold, fresh milk with a fat content of approx. 1.5 % or 3 %. Even homogenized milk is
suitable - if you prefer.
• Use a pitcher (made of metal) with a minimum volume of 0.5 litres. The diameter of the pitcher should
not be too wide. A narrow and high container is perfect.
• Open the steam valve for approx. 5 seconds to release the condensation water and to create dry
steam.
• Fill 1/3 of the frothing container with milk and place it under the steam nozzle. The nozzle should be
immersed in the middle of the frothing container, just below the surface.
• Slowly open the steam handle or the steam valve. Steam pervades the milk.
• Keep the pitcher still.
• After a few seconds you will notice a light suction in the milk jug. Proper frothing begins. Move the
milk jug downwards while the milk level increases. The steam nozzle must be kept under the surface
of the frothed milk.
• After frothing the milk, release the steam into the drip tray to avoid blockage of the steam nozzle.
• Attention: When the desired amount of milk froth is reached, immerse the entire steam nozzle in the
frothing container for a short time and close the steam lever or the steam valve.
• Advice: When milk frothing is finished, just shake the frothing container a little bit in order to make the
milk bubbles ascend to the surface and to get a compact milk froth.
• If you haven´t used up all the milk, you can froth the remaining milk in the pitcher afterwards.
Once this temperature is exceeded, the milk does not froth any further.
In addition to the standard built-in 2-hole steam nozzle, there is a 4-hole steam nozzle in
the Profitec product range which are available at your specialised dealer.
The machine is switched on,
but the machine does not
work.
PID-display is turned off: There
is not enough water in the fresh
water tank
The water tank is not fixed
properly.
Fix the water tank properly.
The machine does not stop
working and takes in air.
Machine in use with water tank,
position direct water
connection).
direct water connection.
The switch is located behind the
drip tray.
Portafilter/ brew group is
dripping.
Portafilter is not fixed properly.
Fix the portafilter properly
Change group gasket and shower
screen.
Portafilter/ brew group is
dripping.
display.
The cleaning mode is
programmed
Clean the brew group. After having
operated the brew lever 10 times,
There is a dot on the display.
The display is switched off.
To Next Page
Loading...
