3
CONTENTS
1. SYSTEM INTRODUCTION – PM200 ...........................................................................................4
1.1 Features 5
1.2 L.E.D Display 6
1.3 Water tank probe 6
2. KEY FEATURES AND FUNCTIONS ...............................................................................................7
2.1 Multiple inputs 7
2.2 Battery Charger of stationery/service battery 7
2.3 Vehicle battery charger 7
2.4 Power supply mode 8
2.5 PWM Solar charger controller 8
2.6 Voltage Charging Relay (VCR) 8
2.7 Categorised outputs 8
2.8 Battery Low Voltage Protection 8
2.9 Manual Battery switch 8
2.10 Silent mode 8
3. STRUCTURE AND INSTALLATION ...............................................................................................9
3.1 PM200 Master Power Unit 9
3.2 L.E.D Display 10
3.3 Water tank probe 11
3.3.1 PMWS400 water tank probe 11
3.3.2 PMWS200 water tank probe 11
4. WIRING .....................................................................................................................................12
4.1 Material 12
4.2 System Schematic 12
4.3 Preparation 13
4.4 Connection 13
5. DISPLAY .....................................................................................................................................14
5.1 PM200 master power unit 14
5.2 L.E.D Display 15
6. OPERATION ...............................................................................................................................16
6.1 Configuration on PM200 16
6.1.1 Battery capacity and battery type 16
6.1.2 Select Battery Switch Local / Remote 17
6.2 Daily maintenance 17
7. TROUBLE SHOOTING .................................................................................................................18
7.1 L.E.D Display on PM200 Unit 18
8. SPECIFICATION ..........................................................................................................................19
8.1 PM200 Basic 19
To Next Page
Loading...
Need help?
General
