CROMOBEAM250
2
WARNING! Before carrying out any operations with the unit, carefully read this instruction
manual and keep it with cure for future reference. It contains important information about the
installation, usage and maintenance of the unit.
SAFETY
General instructions
• The products referred to in this manual conform to the European Community Directives and are therefore
marked with .
• The unit is supplied with hazardous network voltage (230V~). Leave servicing to skilled personnel only. Never
make any modications on the unit not described in this instruction manual, otherwise you will risk an electric
shock.
• Connection must be made to a power supply system tted with ecient earthing (Class I appliance according
to standard EN 60598-1). It is, moreover, recommended to protect the supply lines of the units from indirect
contact and/or shorting to earth by using appropriately sized residual current devices.
• The connection to the main network of electric distribution must be carried out by a qualied electrical in-
staller. Check that the main frequency and voltage correspond to those for which the unit is designed as given
on the electrical data label.
• This unit is not for home use, only professional applications.
• Never use the xture under the following conditions:
• - in places subject to vibrations or bumps;
• - in places with a temperature of over 40°C or less than 2°C.
• Make certain that no inammable liquids, water or metal objects enter the xture.
• Do not dismantle or modify the xture.
• All work must always be carried out by qualied technical personnel. Contact the nearest sales point for an
inspection or contact the manufacturer directly.
• If the unit is to be put out of operation denitively, take it to a local recycling
plant for a disposal which is not harmful to the environment.
Warnings and installation precautions
• Never look directly at the light beam. Please note that fast changes in lighting, e. g. ashing light, may
trigger epileptic seizures in photosensitive persons or persons with epilepsy.
• Before starting any maintenance work or cleaning the projector, cut o power from the main supply.
• Make certain that the xture is o and the temperature of the components cannot cause burns.
• Always additionally secure the projector with the safety rope. When carrying out any work, always com-
ply scrupulously with all the regulations (particularly regarding safety) currently in force in the country
in which the xture’s being used.
• The minimum distance between the xture and surrounding walls must be more than 50 cm and the air
vents at the housing must not be covered in any case.
• Keep any inammable material at a safe distance from the xture.
• Shields, lenses or ultraviolet screens shall be changed if they have become damaged to such an extent
that their eectiveness is impaired.
• The lamp (LED) shall be changed if it has become damaged or thermally deformed.
• Don’t connect the device to a dimmer pack
To Next Page
Loading...
