PROLiNK MASTER II Series - Page 30

28
 Output CURR: Output current calibration. Click value columns and it will pop up . Then, each click is
0.1% no matter it’s pressing up or down key . Press “up” key to increase 0.1% and press “down” key to
decrease 0.1%. Press “OK” key to confirm the modification.
INITIAL
INITIAL menu Page1
INITIAL  Datalog Page
 DATA LOG: After clicking “DATA LOG”, it will pop up a message board as shown in above screen. Touch
“YES” to clear the DATALOG page. Touch “No” to cancel this operation. Touch “ ” to return to
INITIAL menu page.
INITIAL Parameter Page
 PARAMETERS: After clicking “PARAMETERS”, it will pop up a message screen as shown in above screen.
Touch “YES” to restore default value. Touch “No” to cancel this operation. Touch “ ” to return to
INITIAL menu page.