Promac COMPACT PU - PLUS;PLUS+TS Model Advanced Programming Menu; Programming Menu Navigation and Settings

To continue to the next menu press E.
Display indicates
Keybord Type
Esp. Caf. 2esp. 2caf
It is possible to set up the type of pushbutton panel
that applies to all the units. Press A and B to select
key types then E to conrm and to continue to the
next menu.
Display indicates
Doses setting
ENABLED/DISABLED
Dose programming can be activated and disabled
by pressing A and B.
Press E to confirm and to continue to the next
menu.
Display indicates
Continuous key
ENABLED/DISABLED
Press A and B to activate or disconnect continuous
dose supply.
Press E to conrm and continue to the next menu.
The display indicates
Mixed Tea Water
YES/NO
Keys A and B will activate or disconnect the function
of hot water mixing operating the pump.
Press E to conrm and continue to the next menu.
Display indicates
Steam Boiler Gr.
----

Entering the eld relative to TECHNICAL LEVEL
Programming allows programming of particular pa-
rameters or functions.
To enter TECHNICAL LEVEL Programming, the ma-
chine is to be set in the OFF state: keep E pressed
and then immediately C on the pushbutton panel
relative to the rst unit on the left (press C to exit
OFF state). In this state all machine functions are
disabled, only the technical level described above
can be entered.
N.B. Access to TECHNICAL LEVEL programming
and to the programming operations can be carried
out only by the pushbutton panel relative to the rst
unit on the left.
At this point press E for about 10 seconds to enter
the technical level programming menu.
The display will indicate Password, key in the code
number in the technician’s possession on the push-
button panel of the rst two units from the left.
There can be access to the rst technical parame-
ter:
Display indicates
Language
- - - - -
Press A and B to run along the different languages
that can be selected: Italian, French, English, Spa-
nish, German. Press E to conrm and continue to
the next parameter.
Display indicates
Name
- - - - -
The user can set a name with a text which will remain
displayed when the machine is in stand-by phase;
press A and B to select the letters desired, press C
to conrm and continue to the next letter.
Press E to continue to the next menu.
Display indicates
Service Phone
- - - - -
A new telephone number can be inserted which will
be displayed in the case of certain alarms.
Press A and B to select the desired numbers and
C to conrm.
86