ProMinent multiFLEX M10 - Keypad Navigator

M714_User_Master.doc
Updated Aug. 25, 2015 56
4.4 Keypad Navigator 1 of 2
Activity
Top Level
UP DOWN
to:
then
DOWN
& ENTER
then
& Notes
4-20mA Output
MANUAL-AUTO
Output
C1..C8
Configure
ENTER & ENTER to toggle
MANUAL-AUTO
4-20mA Output
Control Modify
Output
C1..C8
Configure
DOWN to Control by:
4-20mA Output
C1..C8 Location
Output
C1..C8
Diagnostic
DOWN to Output Card @:
See Section 3.2, 4 of 4
Alarm Relay OPEN-CLOSE
System:
Configure
DOWN to
Alarm opens contacts
Biocide Cycle:
Set 1, 7,28 days
Output 1..10
Setup
DOWN to Event Cycle
Contact Set to Meter: Modify
Input O..Z
Configure
DOWN to Digital Input Type
ENTER, DOWN to Contact
Head OR Turbine Meter
Control Type
(Action on Setpoints)
Output 1..10
Configure
DOWN to Control Type
Rising/Falling & Between
Setpoints OR Active only
during Timed Events
Default Configuration LOAD
System:
Configure
DOWN to Load Configuration
Restores Default Controller
Default Configuration SAVE
System:
Configure
DOWN to Save Configuration
Makes current configuration
the default
Disable Input
Input A..Z
Configure
DOWN to Disable Input
Disable Output
Output 1..10
C1..C8
Setup
DOWN to Disable Output