ProMinent DULCOMETER D1Cc User Manual

DULCOMETER
®
D1Cb / D1Cc
Assembly and operating instructions
Teile Nr. 986362 BA DM 187 09/11 EN
Please carefully read these operating instructions before use! · Do not discard!
The operator shall be liable for any damage caused by installation or operating errors!
Technical changes reserved.

ProMinent DULCOMETER D1Cc Specifications

General

Type	DULCOMETER D1Cc
Measured variables	pH, ORP, Chlorine, Temperature
Digital inputs	2
Analog inputs	2
Protection Class	IP65
Input Voltage	100-240 V AC, 50/60 Hz
Communication Interface	Modbus RTU
pH measuring range	0-14 pH
ORP measuring range	-2000 to +2000 mV
Temperature measuring range	0 to 100 °C
Measurement principle	Electrochemical
Measured parameter	pH, ORP, Chlorine, Temperature
Display	Graphic LCD with backlight
Power supply	External power supply
Controller outputs	Relay output

Summary

Introduction

Explanation of the safety information

Explains safety symbols and their categorization for user awareness.

Users' qualifications

Defines the necessary training and expertise for personnel operating the device.

General Safety Information

Provides critical safety warnings for operation, installation, and handling procedures.

Commissioning

Initial commissioning

Guide to the first-time setup and configuration of the device.

Selection of the Measured Variable and Measuring Range

Process for setting the correct measurement variable and its operating range.

Operating diagram/ Display Symbols

Fault Messages

Lists and describes device error messages, their causes, and troubleshooting steps.

Measured Variables and Operating Menus for Amperometric Sensors

Calibration of All Amperometric Measured Variables

Outlines the procedures for calibrating amperometric sensors.

Measured Variables and Operating Menus for Potentiometric Sensors

Calibration of pH, ORP and Fluoride Sensors

Maintenance

Fuse replacement DULCOMETER® D1Cb / D1Cc

Safety instructions and steps for replacing the device's fuse.

Summary of Error Texts