8.1 Reduced / Complete Operating Menu
The DULCOMETER
®
D1Cb / D1Cc allows settings to be made in two different compre‐
hensive menus (reduced / complete). All of the parameters of the controller are preset
and can be changed in the complete operating menu.
The controller is delivered with a restricted operating menu. If adjustments are neces‐
sary, the parameters can be changed by switching to the complete operating menu.
general setting
information
Identcode:
D1CB xxxxxxxxxx
Vxxxxxxxxxx
Srnr: xxxxxxxxxxx
alarm relay
access c.:
5000
operating menu
english
reduced
A0088_GB
operating menu
Calib timer
wash timer
_
_
Fig. 41: Reduced / complete changeover
8.2 Description of pH, Redox and Fluoride Measured Variables
WARNING!
Danger of incorrect metering
This can result in hazardous incorrect metering
During initial commissioning, the measured variable and the measuring range of the
sensor must be set prior to calibration. Refer to
Ä Chapter 5.1.2 ‘Selection of the
Measured Variable and Measuring Range’ on page 54
pH Measured variable Typical measuring range
Measuring range - 500 mV … + 500 mV
Display range At least pH -1.45 … 15.45
Reference temperature +25°C
Resolution 0.01 pH
Measured Variables and Operating Menus for Potentiometric Sensors
82
To Next Page
Loading...
