Need help?Do you have a question about the ProMinent multiFLEX M10 and is the answer not in the manual?
General| Brand | ProMinent |
|---|---|
| Model | multiFLEX M10 |
| Category | Controller |
| Language | English |
Details electrical shock hazards and precautions when operating the instrument.
Explains how to view current system status, sensor values, and relay states.
Provides steps for checking and clearing system alarms and viewing alarm details.
Guides users on how to view and modify system setpoints for various controls.
Details the process for calibrating various sensors, including reset to factory options.
Explains how to modify existing biocide feed events and add new ones.
Covers adjusting percentage feeds for pumps, including base feed and bleed feeds.
Details how to manage user IDs and passwords for system access and security.
Details how to configure biocide prebleed and lockout parameters for system control.
Guides on adjusting boiler blowdown timing parameters for optimal system performance.
Explains how to perform diagnostics on sensors, view input card types, and check gain multipliers.
Details how to diagnose control functions, view pump states, and check control parameters.
Provides information on system diagnostics, including firmware version, AC current, and fuse status.
Important introductory information and guidance for setting up the controller and application.
Details typical connections for water meters, flowswitches, and various sensor types.
Provides wiring diagrams and instructions for connecting pumps, valves, and solenoids.
Guides on verifying that sensors match controlled devices and modifying setpoints.
Explains how to set high/low alarms, alarm relays, and alarm delay for sensors.
Details how to configure feed limit alarms, minutes/actuation, and action on alarm.
Describes how to verify and configure interlocks that prevent controls from turning on.
Explains how to set up blocking relays to prevent simultaneous operation of controls.
Covers selection and modification of special controls like 'Bleed then Feed' and % of Time.
Details how to modify variable cycles based on make-up conductivity for bleed control.
Explains how to set up feed verification for inhibitor pumps, including meter and ppm calculations.
Instructions on how to adjust and modify the system's current date and time settings.
Lists part numbers for fuses, controller modules, cables, and other accessories.
Provides contact information, online help resources, and manual download links.
Details specifications for analog/digital I/O, communications, and user interface features.
Guides on navigating keypad functions for various controller activities and configurations.
Records changes made to the manual over different issued dates.
To Next Page