SmartStor DS4600 Product Manual
126
When the upgrade is done, the SmartStor reboots automatically. When the
SmartStor beeps once, it is ready for use.
Please click the System Information button to confirm the firmware version
successfully upgraded.
Error During Upgrade
If an error occurs during the firmware upgrade, the SmartStor cannot reboot in
normal mode. You must boot the SmartStor in Safe Mode and repeat the
firmware installation. See “Booting the SmartStor in Safe Mode” below.
No Reboot After Upgrade
If the SmartStor does not reboot, there might be a service conflict that prevented
the reboot. You must hard boot the SmartStor manually. See “Hard Booting the
SmartStor” on page 129.
Booting the SmartStor in Safe Mode
If an error occurs during firmware upgrade, the SmartStor will not reboot
normally. You must reboot the SmartStor in Safe Mode and repeat the firmware
upgrade
To Next Page
Loading...
